Page 1 of 1

attachment swap

PostPosted: Wed Oct 25, 2017 12:56 am
by nomad
Hello Elec Trak Nation. I haven't been on a while but I use my E20 all the time, especially for spraying a small orchard. Also using an E14 to power a fork lift in my barn and I can get a lot more use of the lofts.

I would love to get my hands on a welder to get more use out of these machines. Anyway, I have 2 mowing decks, a snow blower and a rototiller that I don't use. Mostly use Farmall tractors for that stuff. So willing to trade these attachments.

Willing to sell some of the stuff too if anyone is interested. Just want to see it get used rather than sit.

Eric (nomad)

Re: attachment swap

PostPosted: Fri Nov 03, 2017 7:16 pm
by Rose Sniffer
The GE welder is great. Where are you located? I'm looking for a deck. Do the decks have motors in them? Large or small can? I'm in the Hudson Valley in NY and could mail the welder. Thanks. Phil Hubbard Here's an E-mail if that helps things along qrstu316@aol.com. Thanks again

Re: attachment swap

PostPosted: Sat Nov 04, 2017 2:01 am
by Cave dweller
Hello nomad. Interested in one of the attachments also. Was lucky enough to find an e-15 in good shape with front mower and snow blower but will be doing some veggie gardening and need a rototiller. I'm very new to the elec-trac and have a ton to learn but I figure who better to bother than the folks here on this forum. I am located near the twin cities in Wisconsin so I have a whole winter to start working on this project. Any information would be appreciated.